~*6703-321 Surface gauge. Unmarked except for small user stamps, 10 inches tall with 5 inch and 8 inch arms. Rusty, arms locked with large wingnut. Good (DCR75) 20-40 ~6703-322 Tenoning machine. Looks similar to those made by TWEETEN but unmarked, cuts dowel to replace the ferrule on pool cues. These will run you about $175 new. Has light use and a few spots of surface rust. Good (GRN59) 60-120 ~*6703-323 STANLEY No. 700 vise. Has about 70% grey japanning, surface rust, 5 inch jaws have a few dings. Could use a little grease but still opens and closes fine. Good (GRN51) 20-40 ~*6703-324 Lot of three user made wooden measuring tools. A trammel set with 20" beam, one fixed and one sliding head, needs wedge. Calipers with moving ends, 15 inches long. And a try square with 5-1/2 inch ends. All with some wear. Good- (DCR346) 15-30 ~*6703-325 Lot of three combination squares. A STANLEY No. 21 with a stripe of orange paint on either side, rule has sweetheart mark, moderate wear. One by ORANGE TOOL CO. which was bought by Starrett so their tools are fairly scarce, this one has about 40% japanning, vial looks replaced. And a ATHOL MACHINE CO. No. 500, a company also bought out by Starrett, 60% japanning, vial wet. A few spots of rust on all. Good (GRN52) 30-60 ~*6703-326 Lot of two brass rules. Both have various stamped markings in thousands, one end of one marked "Max. Cap'y. For Motor Truck 12000 lbs" so presumably this measures something along those lines. Some tarnish on both and white paint on backside of one. Good (DCR339) 20-40